CR25 Cluster Remover CR25 Cluster Remover CR25 Cluster Remover - Showing Milking Time in Automatic Mode CR25 Cluster Remover - Showing Conductivity CR25 Cluster Remover - Showing Milking Time in Manual Mode CR25 Cluster Remover - Showing Washing Time Elapsed CR25 Cluster Remover - Showing Washing Time Remaining CR25 Cluster Remover - Showing Washing Screen

CR25 Cluster Remover

The CR25 cluster remover is one of the most useful additions to a milking parlour.

They allow the operator to reduce milking times and improve teat health by automating the removal of the milking cluster from the animals.

They can be used on cow, goat and sheep parlours.

Download leaflet

Cow Cluster CR25 Cluster Remover

The CR25 cluster remover is designed for jar milking parlours and includes option to control jar valves.

Control Features:

  • Simple numeric display of milking time (minutes:seconds) and conductivity (mS - millisiemens)
  • 6 keys - automatic milking, manual milking, wash, conductivity on/off, transfer milk and hold milk
  • Simple, bright LCD display
  • 7 LED windows for auto milking, pulsation, ACR, milk flow, conductivity milking, data and dump line
  • 2 automatic milking modes - 1 time-based cluster removal and 1 sensor-based cluster removal
  • 3 manual milking modes (ACR disabled, conductivity pull off disabled, ACR and conductivity disabled)
  • Time-based cluster removal does not require a sensor
  • Accurate milk flow measurement for ACR timing
  • Full pulsation control - 30 to 180 pulses per minute (ppm) and 35% to 75% ratios
  • Pulsation stop - pulsator only on when milking or washing
  • Stimulation pulsation
  • Washing pulsation - ability to run pulsation frequency at lower rate during washing to reduce liner wear
  • User programmable wash time
  • Wash time elapsed and remaining displayed (minutes:seconds)
  • User selectable conductivity warning and pull off levels
  • High conductivity automatically switches on hold milk so operator can dump milk if required
  • User selectable ACR pull off resistance and time
  • Lift to start ACR cylinder input
  • Meridian 2 communications bus - enables all CR25 controls to be put into milk or wash from 1 control
  • Includes outputs to control jar valves
  • Automatic idle after user selectable period of inactivity
  • Milk sweep / purge
  • Small form factor, allowing for easy installation into existing parlours
  • Suitable for all herd sizes (small or large)
  • Can be retrofitted into abreast, herringbone or rotary parlours

Sensor Features:

  • Free-flowing sensor incorporating shut-off valve
  • The tangential entry and the wide discharge tube allow smooth passage and evacuation of high milk flows
  • The sensor shape reduces vacuum fluctuations
  • The diaphragm shape is designed to prevent accidental closure and allow rapid response, facilitating instant detachment of the milking unit
  • Swirl effect on inside surfaces of sensor induces effective washing
  • The vacuum nipple can be positioned in any direction
  • Milk inlet and outlet nipples - 21mm x 16mm